Chicago Volkswagen Organization
http://forums.chicagovw.org/

DIY Mk1 weighted shift rod
http://forums.chicagovw.org/viewtopic.php?f=27&t=13667
Page 1 of 1

Author:  bronson75 [ Wed Dec 12, 2012 12:32 am ]
Post subject:  DIY Mk1 weighted shift rod

I did this in March this year, before autocross season started. I bit the bullet and got an ABD short shifter for my Scirocco 16v, and I wanted a weighted shift rod to go with it, but I didn't want to spend a bunch of money on it. I went to the hardware store, got about a pound of washers (5/16", IIRC) and went to town. I had 2 neoprene washers on hand (they friction-fit to the rod very nicely, I didn't want the metal washers knocking about on the rod), as well as some only-sticks-to-itself silicone sealing tape. I installed one of the neoprene washers on the shift rod and loaded it up with washers, installed a neoprene washer on the other end, and wrapped the whole works in 2 layers of tape. The rod started out at 4 oz, it ended up at 1.6 lbs. when it was done, and it cost me around $3 all in.
Image
Image
Image
Image
Image

Author:  PuddingTime [ Wed Dec 12, 2012 11:01 am ]
Post subject:  Re: DIY Mk1 weighted shift rod

:thumbup: looks like ill be trying this today, thanks!

Author:  bronson75 [ Wed Dec 12, 2012 2:18 pm ]
Post subject:  Re: DIY Mk1 weighted shift rod

BTW, it's patented.
:whistle:

Author:  PuddingTime [ Wed Dec 12, 2012 4:04 pm ]
Post subject:  Re: DIY Mk1 weighted shift rod

Well in that case... this is what mine "would" look like if I "did" have a go at it :shifty:
Image

Author:  Kamilla [ Mon Jan 11, 2016 10:26 am ]
Post subject:  Re: DIY Mk1 weighted shift rod

This is a very good post which I really enjoy reading. It is not every day that I have the possibility to see something like this.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/